Current Cost Support Forum

I've noticed that if you try to change the low rate price and start times, and you are currently viewing an appliance page, the times you are presented with are blank.

So, is this a bug, or is it possible to set different high and low rates for each appliance and this is actually a feature?

I think it only has one setting which may only effect the primary channel?

If you are writing an application I would not use the internal clock in the display as it tends not to keep good time, no auto summer wintertime change and stops while the unit is in setup. Also no battery backup, it just stops while the power is off.

It is easier then to control the rate price shift in your application with an accurate time source.

Automan.