| Current Cost Support Forum http://currentcost.com/support/ |
|
| Envir for two diferent circuits http://currentcost.com/support/viewtopic.php?f=10&t=24781 |
Page 1 of 1 |
| Author: | airbravo [ Wed Mar 28, 2012 8:07 am ] |
| Post subject: | Envir for two diferent circuits |
I just want to know if it's possible to install just one envir receiver for 2 lines using two coil/current clamps at the same transmiter Circuit 1 (L1-N) Circuit 2 (L2-N) I want to compare 2 air conditioning units working at the same time with same settings and temperature. Regards. |
|
| Author: | Automan [ Fri Mar 30, 2012 7:20 pm ] |
| Post subject: | Re: Envir for two diferent circuits |
I think the answer would be yes but... The but is the display combines the load from one transmitter into one reading. You would also need the transmitter with three input sockets. To see the current measured by each clamp you would then need to hook up a pc to the EnviR to record / view the XML output. May be easier with two transmitters each paired with a different channel on the EnviR. I also assume the ACU are a single phase load? Automan. |
|
| Author: | airbravo [ Mon Apr 02, 2012 7:53 am ] |
| Post subject: | Re: Envir for two diferent circuits |
Yes, it's a simple phase load. So, is it possible to connect two transmitters each paired with a different channel on the EnviR?? This would be a nice solution. |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|