Current Cost Support Forum http://currentcost.com/support/ |
|
RE: Separate transmitter's readings over Bridge? http://currentcost.com/support/viewtopic.php?f=11&t=27505 |
Page 1 of 1 |
Author: | skfisher [ Tue Jun 12, 2012 4:40 am ] |
Post subject: | RE: Separate transmitter's readings over Bridge? |
I have read a post that states that with the PC data cable you can read the XML directly and separate out the power usage on different transmitters. Can this be done with the data sent to Pachube over the bridge as well? I have and EnviR with 2 transmitters. One for a 100amp circuit and one for a 60amp circuit. My understanding of the power reading I get on my.currentcost.com and therefore Pachube is the sum of the two transmitters. Does anybody know if I can separate that data from each transmitter without the need for a data cable to my PC? Sincerely, Stephen |
Author: | SeekerAfterTruth [ Wed Jun 13, 2012 2:44 am ] |
Post subject: | Re: RE: Separate transmitter's readings over Bridge? |
Author: | skfisher [ Wed Jun 13, 2012 5:05 am ] |
Post subject: | Re: RE: Separate transmitter's readings over Bridge? |
Author: | SeekerAfterTruth [ Wed Jun 13, 2012 6:07 pm ] |
Post subject: | Re: RE: Separate transmitter's readings over Bridge? |
I was a civil engineer for 15 years intil i got seduced by the big bucks in IT! So consider this a professional courtesy! Your datastream 1 will be the same data as appliance 0 on your EnviR. On Cosm (https://cosm.com/feeds/<your-feed-Id>) you should see as many feeds as you have paid for; on a Netsmart24 you should see 11 datastreams (0-->10) most will be 0 but you should have values in datastream 2. If it is present on Cosm then you can define it as a channel on my.currentcost.com. If not present then send your bridge serial number to helpme. They need to authorize the extra channels. Hope that helps |
Author: | mekTumKeeby [ Sun Oct 21, 2012 2:24 am ] |
Post subject: | RE Separate transmitters readings over Bridge |
Hi, access log should be enough, nevertheless it could be interesting to have them all separate... Thanks in advance. |
Page 1 of 1 | All times are UTC [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |