| Current Cost Support Forum http://currentcost.com/support/ |
|
| "dev board" instead of "IAMS" http://currentcost.com/support/viewtopic.php?f=15&t=207 |
Page 1 of 1 |
| Author: | ik3ngu [ Thu Jun 16, 2011 5:39 pm ] |
| Post subject: | "dev board" instead of "IAMS" |
Hello everyone, Given unavailability of IAMS on the market, I'm thinking of using "dev board" to build the sensors to monitor portions of my household wiring. The aim is to be able to read between 9 APPLIANCE channels of Envi monitor energy values taken from that specific area of the plant. Perhaps, I could insert it directly into the boxes behind the outlets. Which type to use? Digital or analog? there is someone who has already achieved something? Thanks, Pasquale |
|
| Author: | warwickwater [ Wed Jun 22, 2011 11:00 am ] |
| Post subject: | Re: "dev board" instead of "IAMS" |
How on earth are you going to connect between the low voltage dev board and the mains to be measured? Theres a lot of scary mains circuitry needed between the two! |
|
| Author: | ik3ngu [ Sat Jun 25, 2011 9:10 am ] |
| Post subject: | Re: "dev board" instead of "IAMS" |
| Author: | SaFeHeX [ Mon Jul 04, 2011 1:14 am ] |
| Post subject: | Re: "dev board" instead of "IAMS" |
| Author: | ik3ngu [ Wed Jul 20, 2011 8:19 pm ] |
| Post subject: | Re: "dev board" instead of "IAMS" |
Hi SaFeHeX I am convinced of the difficulty. I think at this point that I will wait for a commercial product ready. many thanks Pasquale |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|