Current Cost Support Forum http://currentcost.com/support/ |
|
battery backup http://currentcost.com/support/viewtopic.php?f=8&t=16 |
Page 1 of 1 |
Author: | Norman [ Sat May 28, 2011 1:19 am ] |
Post subject: | battery backup |
hi, I have the EnvIR with the one current clamp at the moment but once the solar goes in, in 3 weeks time I will hookup a second clamp to it. I have a question which would lead to a request. The time on the data sent to my PC which is then sent off to GooglePowerMeter where does that come from? is it the system time? or is it from the EnvIR? it if is from the EnvIR then could we have a battery backup installed in the unit? to maintain the integrity of the data? Sorry I posted to General instead of suggestions but for some reason I do not have access to post to the "suggestions" forum? Norman |
Author: | Alternative [ Tue Jun 07, 2011 4:33 pm ] |
Post subject: | Re: battery backup |
I also have solar PV and want to do the same as you, but can't get the display to separate the two sensors readings. I have also posted this in a different forum section on Displays, under EnviR with Two Sensors. |
Author: | webbj [ Thu Jun 09, 2011 1:01 am ] |
Post subject: | Re: battery backup |
Author: | spongeface [ Sun Jun 19, 2011 12:03 am ] |
Post subject: | Re: battery backup |
I have two transmitters, one for the house and another for a solar panel. Yes they are separate on the display - I use the up/down buttons to go between the main display and "Appliance 1". On the Current Cost Dashboard and on Google Power Meter, only the main output is displayed. How do I see the second transmitter's data in the dashboard and Google PowerMeter? |
Author: | currentcost [ Mon Jun 27, 2011 12:57 pm ] |
Post subject: | Re: battery backup |
the multi appliance bridge is under test at the moment. this should be released very soon in the next month. |
Author: | Automan [ Mon Jun 27, 2011 1:13 pm ] |
Post subject: | Re: battery backup |
Author: | matelodave [ Mon Jun 27, 2011 5:34 pm ] |
Post subject: | Re: battery backup |
What funcionality has the multi-appliance bridge going to have - will it be able to output the seperate phase info as well?. As previously asked is there an upgrade path (reflash/update of firmware for instance) or will we slowly end up with a small pile of dead bridges in the back of the cupboard as new functions are added. |
Author: | Jason [ Mon Jul 04, 2011 12:55 pm ] |
Post subject: | Re: battery backup |
Page 1 of 1 | All times are UTC [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |